Tool Wanted Head clearance tool

[NAMBA860]

I believe Terry Keeley made some little gauges that slipped through the glow plug hole to check the head clearance. Does anyone have this tool they would part with?

 

[Kristy Wallace]

I believe Terry Keeley made some little gauges that slipped through the glow plug hole to check the head clearance. Does anyone have this tool they would part with?

Old school .Use Solder .or use dial callipers

Or,

Contact Daniel place and see if he has any dial gauges in stock. Look up the manufacturer page he will be there .

 

[FloridaScaleBoater]

Plasti guage..
Amazon

 

[Davidkrienke]

I second the solder and dial calipers. Always works for me . I usually just feel along the smashed out solder with the calipers and find the thinnest reading and that is where the squish is at.

 

[Roxyflash]

You can also use a depth micrometer bolt liner down on a couple screw holes bring piston up to top dead center measure the flip the head button measure the step then subtract the two numbers