2025 Backlash

[Roxyflash]

Would sit to high the wire ties will do the trick

 

[Martin Law]

Bruce,

The tank sits on the bottom of the tub. The strips are on both sides of the tank so no height added. The velcro across the top is no higher than the vent tube bubble.

Marty

 

[Roxyflash]

That would work I’m happy with zip ties will post some more pictures tonite trimmed the cowl added the tongue next will be cowl magnets.

 

[Roxyflash]

Glued a piece of g10 for the tongue it centers the front of cowl perfectly cut the plug hole and exhaust cut out here’s a couple pictures.

 

[Roxyflash]

Epoxied a piece of g10 for magnet mounts used some of the 1/8x1/4 bass wood sticks around the perimeter to glue the g10 onto was simple had it fabbed up in no time.I found these mounting magnets on Amazon under 10 shipped I used 6/32 screws to mount them I need to find some 6/32 fender washers for the cowl under the acorn nuts next is sanding and sealing.

 

[Brian Schymik]

Epoxied a piece of g10 for magnet mounts used some of the 1/8x1/4 bass wood sticks around the perimeter to glue the g10 onto was simple had it fabbed up in no time.I found these mounting magnets on Amazon under 10 shipped I used 6/32 screws to mount them I need to find some 6/32 fender washers for the cowl under the acorn nuts next is sanding and sealing.

I’m worried the cowl magnets will not hold. Lots of vibration !

 

[bzubee]

I’m worried the cowl magnets will not hold. Lots of vibration !

I did my cowling like , but Brian stated in race water vibration over came the magnets so I added a set of Orange style cowling hold downstairs in addition to the magnets works great now

 

[doug long]

I agree, hard to imagine them holding during a run.

I did my cowling like , but Brian stated in race water vibration over came the magnets so I added a set of Orange style cowling hold downstairs in addition to the magnets works great now

Please show us pictures and where did you buy the orange style from.
Thanks

 

[Roxyflash]

I have used magnets before with no issues there’s 20 lbs of force holding the cowl down I have the magnets down far enough that the washer sits in between the tub sides and the front of radiobox to keep it from sliding I may have to put some thumb nuts on the cowl to have something to grab or may drill a hole in the cowl toward the rear I can put my finger in to pull the cowl off it’s really on there.I use magnets on my f41 cat and used magnets on several other boats

 

[dr gary turner]

I would recommend Total Boat Penetrating 2 part sealing epoxy from Jamestown Distributors.

Penetration is excellent and easy to sand.

 

[doug long]

I would recommend Total Boat Penetrating 2 part sealing epoxy from Jamestown Distributors.

Penetration is excellent and easy to sand.

????