First time hardware set up

[Greg Ruggles]

This is the first time I'm setting up the running hardware on this 46" twin craft with a picco 90, what are your thoughts and/or suggestions on the placement of everything? Also, any suggestions on what prop(s) to tryout? The one in the picture is the only 1/4 " shaft prop I have. Alan Elzer, a very great help/person is looking into ABC props for me.

 

[Greg Ruggles]

This is the first time I'm setting up the running hardware on this 46" twin craft with a picco 90, what are your thoughts and/or suggestions on the placement of everything? Also, any suggestions on what prop(s) to tryout? The one in the picture is the only 1/4 " shaft prop I have. Alan Elzer, a very great help/person is looking into ABC props for me.

One more picture

 

[shoboat]

Greg,

Are you starting out with an X-467? If that is not enough
an X-470 with reduced diameter will be another good
choice. Jim at ABC does have some new blades out in
the testing stage of production.

Looks Good,

Mark

 

[Wasted wages]

Man , that’s a lot of hardware hanging off the back of that boat!!

 

[FloridaScaleBoater]

This is the first time I'm setting up the running hardware on this 46" twin craft with a picco 90, what are your thoughts and/or suggestions on the placement of everything? Also, any suggestions on what prop(s) to tryout? The one in the picture is the only 1/4 " shaft prop I have. Alan Elzer, a very great help/person is looking into ABC props for me.

The hardware setup looks real good.
The only thing I would suggest different is to turn your turn fin brackets 180* so the fin is outboard more, closer to the chines.
And they look like they are, but make sure they are 90* to the bottom of the hull.
Nice work

 

[Greg Ruggles]

Thanks for the response. Still learning the do's and don'ts...but I'm learning. I think.

 

[bzubee]

This is the first time I'm setting up the running hardware on this 46" twin craft with a picco 90, what are your thoughts and/or suggestions on the placement of everything? Also, any suggestions on what prop(s) to tryout? The one in the picture is the only 1/4 " shaft prop I have. Alan Elzer, a very great help/person is looking into ABC props for me.

This is the first time I'm setting up the running hardware on this 46" twin craft with a picco 90, what are your thoughts and/or suggestions on the placement of everything? Also, any suggestions on what prop(s) to tryout? The one in the picture is the only 1/4 " shaft prop I have. Alan Elzer, a very great help/person is looking into ABC props for me.

Since it's a twin craft I would try to contact John Finch or Dick Tyndal they are both experts with that hull.

 

[Greg Ruggles]

Since it's a twin craft I would try to contact John Finch or Dick Tyndal they are both experts with that hull.

I will try reaching out to them, thanks for the advice.