Cowl Securing ???

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Neodymium rare earth magnets totally rock. B)
I was looking here-

http://www.rare-earth-magnets.com/magnets.htm

And was wondering, could the "rod type" magnet be used on the forward end of the cowl with the " flat block type" magnets used under the lip of the deck, then a pair of flat block style on each rear corner ??? once in position I could notch the flat part of the magnets under the cowl on each side to properly align the front of the cowl.

http://www.rare-earth-magnets.com/detail-ID-83.html

http://www.rare-earth-magnets.com/detail-ID-98.html

Andy

Another place to get these magnets is here: www.kjmagnetics.com

If you look at the ring magnets in there product list and scroll down, you will see them in pairs. The pull force on the 3/4" ring magnet is over 33 lbs compared to the ring magnet from Magcraft at 5.8 lbs! :eek: I ordered some of these from KJ Magnetics for holding my sport 40 and scale cowls in place. I don't think there is too much that will knock these things apart. The only thing now is, I don't know how I'm going to get the cowl off after the race :lol: :lol: :lol: :lol:

Dave
LOL :lol: :lol: :lol: :lol:

Heck the one's I have are hard enough to pull apart now.

M
 
The only thing now is, I don't know how I'm going to get the cowl off after the race :lol: :lol: :lol: :lol:

Dave

LOL :lol: :lol: :lol: :lol:

Heck the one's I have are hard enough to pull apart now. If your using 5 min epoxy - MAKE SURE you have the poles correct on the magnets, because by the time you get done prying them back apart from making sure, your epoxy kicked and you start over :rolleyes:

Me and my daughter had a grand time playing with them prior to install and with the left-overs :lol:

You could flip and spin the round one's with the longer round magnet from underneath a 3 inch wood table :huh:

If you used the whole pack, you could get it dancing pretty well :p

Andy
 
Last edited by a moderator:
Back
Top