Vertical Fin Hardware Mounting

[Russell Bear]

Anyone have any pictures showing the mounting hardware for the vertical fins on a scale boat? Mainly looking for pictures of the wire supports both secured to the transom and the verticals.

Thanks.........

 

[Paul Pachmayer]

Hi RB,

Here's my Atlas mounts;

Paul.

 

[P THOMAS]

Here is the set up sheet I send out with my scale hydros that have rear wings

Hope this is clear enough to see the hardware and part # for the fittings I use

If you click the image it goes to full screen you can read that one

https://www.intlwaters.com/gallery/displayimage...album=189&pos=5

 

[Russell Bear]

Phil, Must be a monster of an image. I have roadrunner and it still times out..

Fatal error: Maximum execution time of 30 seconds exceeded in C:\Inetpub\ftphosted\iwatersGallery\displayimage.php on line 27

Oh, there it is. Thanks Phil.........

 

[P THOMAS]

ok I made it smaller mabe that will give you a good idea on how to mount

the rear wings. This is a real solid way of mounting wont come off in a flip.

 

[P THOMAS]

https://www.intlwaters.com/gallery/displayimage...album=325&pos=3

here is a scale rear wing mount I made

There are 4-40 rods inside the brass streamline tubes.

 

[hgatjens]

How we did it on my 1994 Budweiser t3

http://www.gatjens.com/wing/wing.htm

 

[Russell Bear]

Thanks Phil, Thanks Harry.

Is there any shots out there of how the wire supports attach to the verticals towards the top? I assume it would want to be mounted in a way that if it blew over it would want to come off "fairly" easy without breaking something.

Thanks.........