TS2 and RC needle

[f3cheli]

Hi

Is there anyone here who has managed to setup an RC needle/fuel valve on the TS2 with the stock fuel tank? The problem is that I dont find a good route for the wire pushrod that will be connected to the needle. An narrower (word?) fuel tank would for sure help, but I like the stock fuel tank.

Andreas

 

[Jerry Dunlap]

I have an onboard mixture control on my TS with the oval tank supplied.

JD

 

[MarkScott]

Are you talking about using a 3rd channel setup? I did one on my TS2, but it was using a metal tank, not the stock one.

 

[f3cheli]

JD, do you have a picture of your TS2 with that setup?

Andreas

 

[Jerry Dunlap]

JD, do you have a picture of your TS2 with that setup?

Andreas

I'll post a photo.

JD

 

[Jerry Dunlap]

JD, do you have a picture of your TS2 with that setup?

Andreas

I'll post a photo.

JD

JD, do you have a picture of your TS2 with that setup?

Andreas

I'll post a photo.

JD

 

[f3cheli]

JD! My TS2 doesnt really look that way, have you raised the fuel tank?

Andreas

 

[anders-e]

JD were did you get the RC needle

on the picture,

I have one from precision boats but

can´t find it on the web anymore

I need two or three more

would be glad to know were i can

get them

Anders

 

[Jerry Dunlap]

The remote mixture control in the photo is by Mark Grim. His e-mail address is: [email protected]

Don Ferrette, an IW regular, also makes a remote mixture control.

JD

 

[anders-e]

sorry JD i did get the mail back on the following address

[email protected] must be wrong

Anders

 

[topfuel443]

Hey Anders, im gonna venture to say that Jerry meant to type "mgrim" instead of "mgraim" since his name is Mark Grim. Give that a try.

Andreas, I would also venture to say the pic of the TS doesnt look like yours because the picture may be of the protoype TS 3 that the Aquacraft guys are working with??

but what do I know?.....not much.

~James

 

[Jerry Dunlap]

Hey Anders, im gonna venture to say that Jerry meant to type "mgrim" instead of "mgraim" since his name is Mark Grim. Give that a try.

Andreas, I would also venture to say the pic of the TS doesnt look like yours because the picture may be of the protoype TS 3 that the Aquacraft guys are working with??

but what do I know?.....not much.

~James

Hey James,

Two for Two. It is Mark Grim and that's a prototype TS in the photo. However, I've also run a similar mixture control on a TS2.

JD

 

[topfuel443]

Woo Hoo!!! Ding Ding Ding...



Jerry, I just found out we may be heading out your way when we leave Germany in a few years. Portland is where the headquarters is for Army Corps of Engineers and that is who my wife works for. You guys got room for another tunnel freak over there in the district?

~James

 

[Jerry Dunlap]

Woo Hoo!!! Ding Ding Ding...



Jerry, I just found out we may be heading out your way when we leave Germany in a few years. Portland is where the headquarters is for Army Corps of Engineers and that is who my wife works for. You guys got room for another tunnel freak over there in the district?

~James

Hey James,

Portland is about two hours away from our pond and about the same time from the pond in Springfield where Lohring Miller runs.

Another outboard racer is always welcome.

JD