The beginning of a twin

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I've had great results with a large flush trim router bit on a good router table.  Ruff the cut, and go to the router table.  No need for sandpaper and you will never screw up your template by over sanding.  The inside 90 degree corners will need to be hand finished. 
 
2 sets of rear sponsons built yesterday at the Mark Bullard shop.

Also the roter was put to use.

The top was glue on the tub WHILE IN THE JIG.  Then the compartments were rotered out using jigs.

Brass tubing is for the pipe pressure 

B35F7135-893B-42D2-A340-7B9A70624C3D.jpeg

E667C334-4C36-4D37-BA28-7E5F333626F0.jpeg
 
Doc 

will you order new 2019 CMB91 M-line red headed more powerful than CMB EVO ? 
 
Last edited by a moderator:
Coming soon 

will you sell CMB EVO ? LOL.

I don’t like four bolts on head because weak compression 

better six bolts head more seal and strong compression 

I will order one and will order build new Special  SGX “single engine “ from Andy Brown 
 
Back
Top