SST Twin G2

[Steve Caines]

Allan,

Nice running boat!!!!!!!!!!!!!!

I love CMDI Eagles...CONGRATS!!!

mmmmm....sst..??

 

[Jose F Cid]

Steve,

I guess it came out the wrong way as I meat to say I love the CMDI boats as I know Allen has a few of them.... And Congrats on his new SST....I guess that next time I shall be more specific.

Jose

 

[brett english]

allan the boat looks good!! seen SST"s run in person...very fast boats!!! good luck

 

[Steve Caines]

Steve,

I guess it came out the wrong way as I meat to say I love the CMDI boats as I know Allen has a few of them.... And Congrats on his new SST....I guess that next time I shall be more specific.

Jose

No worries Jose'. I can't say too much, but being busy on other projects, and I've had a SST Twin sitting in my shed for about 18 months. At this stage looking to hit the track with it this Sept.

 

[Jose F Cid]

Steve,

I have been the same too busy with work and both my boats are sitting in the garage....I hope to get out to the lake soon!!!

Good luck wih your SST and post some pictures when you get it running....

Jose

 

[John Hudson]

Who can I contact to enquire about these Sst boats?

 

[ALLAN YUEN]

Who can I contact to enquire about these Sst boats?

Contact to Mark Bullard He build his design SST twin in limit very rare

 

[Piston1]

For anybody that saw the video in this thread, it is a reminder of why Half course mill is a dangerous start for fast Hydros.

 

[ALLAN YUEN]

On launch of your boat you must first complete a full lap of the course. If you cut into the course at any point before your first lap results in a penalty (one lap per infraction)After this lap is complete the Milling Pattern is in effect. You can only cut across the front side of the course. NO cutting in on the back straight and drivers in the back straight have the right of way.