- Joined
- Oct 26, 2008
- Messages
- 631
I did this just for fun. I was able to find 2 new sleeves but I wanted to see if this could be done and wanted to try a turbo plug head. Someday I will put the right sleeves in.
I finished the car sleeve on my xm Its at 124 transfers and 181 ex I shimmed it with 19mm toyota oil drain washers then raised the ex with a carbide. it was actually at 124 160 stock. So the scanner rc 3 port 21 sleeves work with stock timing for the muffler and I can readily get them if anyone ever wants to do it ..Then I took down the new turbo plug head so I can go as close as 2 thou I have it at 7 to 8 right now for break in . I didn't do any crank timing yet. I want to see what it runs like first. I heated it up then started it and let it run some still really tight. I brazed a brass tube in the primer hole of a shell casing then pinched the end to get the flow I wanted. I need to find more rubber caps like this one I am unsure what its off of .. I melted a hole in the top with a rod to inject oil. The cap acts like a primer bulb when I was done I just pulled the hose and pushed out the unused oil. The blue head is 2 back to back water cooled tops put together.
I finished the car sleeve on my xm Its at 124 transfers and 181 ex I shimmed it with 19mm toyota oil drain washers then raised the ex with a carbide. it was actually at 124 160 stock. So the scanner rc 3 port 21 sleeves work with stock timing for the muffler and I can readily get them if anyone ever wants to do it ..Then I took down the new turbo plug head so I can go as close as 2 thou I have it at 7 to 8 right now for break in . I didn't do any crank timing yet. I want to see what it runs like first. I heated it up then started it and let it run some still really tight. I brazed a brass tube in the primer hole of a shell casing then pinched the end to get the flow I wanted. I need to find more rubber caps like this one I am unsure what its off of .. I melted a hole in the top with a rod to inject oil. The cap acts like a primer bulb when I was done I just pulled the hose and pushed out the unused oil. The blue head is 2 back to back water cooled tops put together.
Attachments
Last edited:
