- Joined
- Jan 2, 2006
- Messages
- 3,073
Which hull are you thinking about?Wasted, I would offer to print you a couple stand ends. But the angle would probably be too shallow for your hull.
Which hull are you thinking about?Wasted, I would offer to print you a couple stand ends. But the angle would probably be too shallow for your hull.
I got one with a boat I bought here on IW..If you screw the PVC stand together instead of using glue, it can be taken apart
What is the width of your stand?The hull deadrise angle on the files that I printed from are only 18 degrees. Most mono hulls are going to be more than that. I don't have the capability to change the angle from the file that I have.
Jay, what did you use to attach the joints ?Ski poles & copper elbows.View attachment 311247
My PVC MONO stand has lasted at least 15 years. Easy cheap.
Remember, it’s just a boat stand!I have had mine for 15 plus years.
They’re a tight friction fit for now. I might use some BHCS or something eventually.Jay, what did you use to attach the joints ?
Any clues on where to find ski pole material?They’re a tight friction fit for now. I might use some BHCS or something eventually.
For several years I have been drawing out simple 2D templates for the V-angle and having master's laser cut in acrylic. I use a router table and flush trim bit to cut marine ply or any wood board into a stand. Drill some 3/4" holes and buy some wood dowel.
For small mono's like 21's I have been direct 3D printing stands in PLA. Sorry I don't have a picture of the actual stand, but here is a screenshot in CAD. I'll add some silicone rubber strip to the areas which contact the hull and on the bottom of the stand so it does not slide around. Probably uses $10-15 worth of material.
View attachment 311236
try sending to my email and see if that works.Sorry Fons for not replying sooner, I was out of the country. The STL files are quite large. If this does not work I will convert into STEP and you can do the STL conversion.
-Tyler
Enter your email address to join: