micro boats

[larcor69]

I just got a 12" hydro hull and was planing on a brushless 380 5800kv size motor I need some hints if you have them and I will need some sort of coupler to a flex shaft .98 size any help would be greatly appreicated

 

[Randy Naylor]

I run Micros quite a bit. I build special couplers for the 2mm shafts if you have a 1/8 shaft then a Octura flex hex is the eazy way out.

Randy

www.bbyracing.com

 

[Ralphie]

Finally got some smooth water and a chance to try out my Renegade Rigger with the metal prop on her........WOW this Little Booger can FLY. I thought it was fast with the plastic prop but it is insane with a metal prop. What a FUN little rigger

 

[Speed Jr.]

Finally got some smooth water and a chance to try out my Renegade Rigger with the metal prop on her........WOW this Little Booger can FLY. I thought it was fast with the plastic prop but it is insane with a metal prop. What a FUN little rigger

Ralphie, cut that skeg off the bottom of the strut, then sand smooth, its not needed, just extra drag. With a boat as small as that, it should make a 2mph+ difference.

Larry Jr.

 

[Ralphie]

Thanks will do .