Hydro engine mounts - 21 and 91 sizes - Where can I buy them

[Shane Bastick]

I need some 21 outrigger engine mounts like the one's used in most modern outriggers, and also mounts to suit CMB 91Rs engines, standard alum bar type with the nylon bolts, have tried a couple of sources and cant get anything, does anyone have any ideas

 

[javier molina]

Speedmaster and accutech

 

[moparbarn]

Aeromarine, you will to call them. they're redoing the website.......

 

[dr gary turner]

Make them out of Delrin light and strong. Nylon bolts through the sides that go through rubber grommets and nylon spacers to get the spread rigth. Spacers at Lowe's, Delrin and grommets at McMaster Carr.

 

[David Murany]

Make them out of Delrin light and strong. Nylon bolts through the sides that go through rubber grommets and nylon spacers to get the spread rigth. Spacers at Lowe's, Delrin and grommets at McMaster Carr.

This is how we do all of ours. Works very good.

 

[Shane Bastick]

thanks guys, I have actually done that with a twin project, I just wanted to buy some mounts this time

 

[Shane Bastick]

Hi Greg,

are your rails similar to say the CMDi mounts

 

[Shane Bastick]

Hi again Greg,

what about the CMDi mounts that fit the CMB 91RS engines, are you able to machine that type as well,

 

[dschigoda]

Make them out of Delrin light and strong. Nylon bolts through the sides that go through rubber grommets and nylon spacers to get the spread rigth. Spacers at Lowe's, Delrin and grommets at McMaster Carr.

I picture would be worth a thousand words...

 

[Kevin Krogness]

What size nylon nuts are you guys using? Putting toghether a hobbyking order and all they have is M3.... Seems to small...