Hardware Needed

[toadstoys5]

Looking for a little help with propellor recommendations for a scale R/C cruiser. Boat is approx 50" long, about 22" wide and weighs in excess of 30+ pounds. Yeah I know its pretty much a beast. Its all wood and has a 50cc gas watercooled engine. I didn't get a prop with the boat and have no idea what to run. It's a submerged drive (hardshaft) and I'm going to be needing something that will simply cruise the boat along. This is not a speed machine just a very scale looking "Cris Craft" type cruiser. If anyone could help me out with some ideas and maybe where I could locate some deck hardware also. Unfortunately the rudder was broken off its shaft so that will need to be replaced also. So: I need a prop, rudder blade and rudder shaft, and any scale deck hardware i.e. cleats etc. Any help would be greatly appreciated. Thanks.

 

[topsecretboats]

HELLO FROM TOP SECRET BOATS ,

YOU MIGHT TRY A 275 PROP. IT WORKS ON EVERY THING MAY BE NOT THE FASTEST PROP.

BUT EASY TO GET AND A GOOD PROP TO START WIH.

AS FOR HARDWARE YOU GOT TO GO TO TOPSECRETBOATS.COM

GOOD LUCK WITH YOUR PROJECT.

BILL.

GAS BOATS ARE NOTHING BUT FUN