Futaba 3pm-fm for remote needle valve

[kenrc]

I have looked at the manal and can not tell if this radio can be used for this type of use or will it travel the full servo distance every time you hit a button.

 

[Bob Kensill]

You can make one of the "thumb" switches operate the third channel for linear operation.

 

[kenrc]

I have looked at the manal and can not tell if this radio can be used for this type of use or will it travel the full servo distance every time you hit a button.

Can you explain more?

Will one button go both lean and rich?

Can you move it to were you feel it is right setting or dose it move to a pre set position?

 

[Terry Flynn]

I have looked at the manal and can not tell if this radio can be used for this type of use or will it travel the full servo distance every time you hit a button.

Can you explain more?

Will one button go both lean and rich?

Can you move it to were you feel it is right setting or dose it move to a pre set position?

I Had the same problem as you did read the manual and worked on it for 2 hours. Know if I had some one around that was 10 years old i might have gotten it done in about 5 min. lol

Turn to page 29 in you book. it says to turn on the power switch while holding the SEL button from there you can scroll through the menu and change all your trim control placement. good luck.

Terry