Dubro 3.5 outboard mount dimensions

[Terry Michael]

Does anyone have the dimensions of the width and height of the Dubro 3.5 outboard mount of the bracket when assembled, that bolts onto the transom.

Cheers

 

[moparbarn]

terry, the total footprint/ size of the mount brackets at the transom is : 2 1/8" wide X 1 3/4" tall

mount bolt pattern is: 1 1/2" wide X 1" tall

set back (transom to pivot pin): 1 1/8"

total up & down adj. is 1/2"

tilt/trim is dependent on whether you mount the trim adj. slot at the top or bottom. either way gives more adj. 1 way than the other, but affects prop height differently. i try to keep my adj. slot on the bottom, full scale ob's pivot that way......must be a reason B) . it may depend on any transom angle built into the hull, leaving you no options.

 

[Terry Michael]

terry, the total footprint/ size of the mount brackets at the transom is : 2 1/8" wide X 1 3/4" tall

mount bolt pattern is: 1 1/2" wide X 1" tall

set back (transom to pivot pin): 1 1/8"

total up & down adj. is 1/2"

tilt/trim is dependent on whether you mount the trim adj. slot at the top or bottom. either way gives more adj. 1 way than the other, but affects prop height differently. i try to keep my adj. slot on the bottom, full scale ob's pivot that way......must be a reason B) . it may depend on any transom angle built into the hull, leaving you no options.

Thanks for the info and advice moparbarn much appreciated mate.