Search results

For Sale Futaba 4PX Transmitter Sold Please read the entire TXT Futaba 4PX Transmitter with 2ea R614FS 4 CH FASST Receivers plus 1 ea. Futaba HT5F1 NiCad TX battery & 4PK Hard Carry Case (has small dents & scratches on the hard case) 3 years old in very good condition everything is 100%...

So after the better part of the month off (holidays) I was able to to get the center section deck and cowls , Scale Driver roughed in. Just have to mock up the cooling water lines and servo mount and rudder steering linkage . Then I can get the main decks installed. And move on to my LEAST...

SOLD These items are all New never installed (wired and rotational tested only) 1/8th Scale FE, Motor, Floor Motor Mount, ESC.& Programing Card New Retail Cost NEU 1527 1.5Y 850 Kv with cooling water jacket $...

Take a look at ML Boatworks he has way more options for 1/6th scale Gas hulls https://mlboatworksrc.com/

ISO a 1/10th scale dashboard decal similar to one the pictured 1/8th (this 1 is offered on Rattlesnake RC )

REALLY

Finally able to get back to this build after my hip surgery. Motor mount, strut and flex shaft log installed. On the top installed the upper mid deck section's leaving the main deck off till the sponson skins are finished. All sponson skins except the right side main ride pad are completed...

Speed Coat https://www.chemical-supermarket.com/Speed-Coat-Aerosol-p623.html

Phil Thomas Stealth 45 CMB .45 V5. Built for NAMBA D-8 2020 season

All ready tried Scale-3D no reply back :mad:

ISO a 1/10 scale driver Figure the late 70's to the 80's era WHATs YA Got re waste up form

Finally able to start epoxying on the bottom skins on added some balsa to increase the glue surface on the sponsons and rear non-trips. I never have trusted gluing to 1/16th plywood on edge. I'm also going a different route on the skins material going to use .015 G-10 fiberglass instead of...

So on a 1/10th scale Fe hydro using a 3/16 Reverse Right Hand Wind cable is it necessary to use a thrust washer to stop end-loading the motor bearings most small motors bearings are not designed to take much thrust loading. And is the best location at the strut or between the the flex shaft...

Finally heard back from Mitch there on there way TNX Mitch

No problem Tim That's what all about racers helping racers. Unless we have to race against each other then Ur on Ur own LOL:):):)

Since Stu Barr is a stocking CMB parts dealer he should be able to get U that info

TNX FOR THE INFO EVERYONE no further info needed AGN TNX

TNX Jerry The reason for the ?? I was more looking to try and save weight by going to say a 4s 2 or 3000 mHa. I read in Ur build thread when Ur THE BOAT crashed the broke the sponson, noise the thing either came close or did sink. Plus less weight means better acceleration. I have bought many...

What is the smallest mAh 4s 20to 60c Lipo is need to safely finish a normal start clock & heat race. I am more concerned with weight then the number of heats. Sooner change the battery after each heat then haul around to much weight

Sorry they sold before I heard back from you TXT ME for my Pay-Pal info TXT to 360 618 two eight four nine