Search results

Hey Rick. Check IM

Are there any images of the tee shirt art work?

Ok Doc, I'll pull my F mono out and enter it. I can make it on Friday the 10th

I have a 36x66 shop building adjacent to the house that is a work in progress. Mainly metal working equipment: TIG, MIG, Plasma, 20T press, bending brake, chop and band saws, blast cabinet, mill, lathe, etc. Also have a few wood working tools, a composite layup area, parts washer, vacuum table...

Mark, is that 6319 bearing for you new F motor?

Hmmm, won't let me edit. I'm still around, though not as active in boats as i would like to be. Just not enough time rebuilding our farm into a wellness education facility for our retirement. I intend to get back into boating once i get some major projects done. Had some setbacks the last couple...

I carry the WIB bearing. Greg Settle swore by the accuracy of the WIB races and bougjt many for parts to size with ceramic balls. He was meticulous and made custom clearance bearings. We had many discussions about bearings and motors in general.

Did you get what you needed? I have seversl back plates with rotors.

Jim, i'm in Shelbyville and have been playing with these darn toy boats for 40 years. When I run, I go down to Huntsville. We had a club in Nashville 25 years ago, but members went their separate ways and the pond got swallowed up by a subdivision. Let me know if I can help, I have 40 years...

3PK, or 3PK Super? My 3 PK Supers have no problem restrating at the same trim as when turned off.

Brad, i can offer $245 shipped to TN. Let me know if this is acceptable, and we will work out the details.

Yes Terry, they did. In 1 case I believe that the TX coax cable had failed at the pivot joint. IIRC, that TX trashed 2 different hulls. I almost launched my F mono with no rudder control. The boat checked out fine on my table, but after starting and getting on the driver stand I performed the...

I have the pipe epoxy for my square wave pipes. It requires a multistage high temp oven cure cycle. I can repair your pipe by adding a small carbon braided sock over the damage to reinforce. Depending on the resin used, internal erosion of the pipe can occur. I have repaired several gadget pipes...

Gabe, I need to edit. They are 3PJ, 1 is a Super.

After much debate i've decided it's time to start finding homes for some of my extra stuff. First to go is a pair of 3PJ radio sets. One TX is 3PJ Super. Both radios are 75 mhz with synthesized RF modules. Each comes with a LiPo battery pack and r113i receiver. $85 ea shipped in USA. Buy both...

CMB Gran Prix 90. $150 shipped Sent from my SM-N920V using Tapatalk

The BOCA chart is usually pretty accurate. I think most of the purple head EVO were needle bearing on the carb end. We are talking the early stacked crank EVO like the RS, right? Honestly the CMB motor bearings are confusing. The new EVO are dual BB like the RS. Do you know approximate year of...

I have them in stock. Rear bearing is a needle bearing, right? Needle should be 12/19/12, front is 6001. Only have a few of the needle bearings left. Sent from my SM-N920V using Tapatalk

Im interested Mike. How is the sleeve fit and there been any case or sleeve timing work done? Sent from my SM-N920V using Tapatalk

Dang it David... beat me to it. I lnow David will complete his purchase, so no need for me to get in line..... Sent from my SM-N920V using Tapatalk