Search results

Looking for a NIB Greenhead. Unmolested bone stock. Could also use a AB 5 degree header. And Muck or CMB quiet pipe. Thanks, Glenn

Is there a specific reason for not using Alum. on this project Don?

Thanks Grim, I was hoping to hear something positive . Radio will be a Futaba on 2.4 and would like to stay with the 5 cell hump battery packs for now. I believe I did read a thread about using non-regulated 6.6 life batteries not long ago and it was not the best choice for everyone.

:)Don't heat it in the wife's oven Don, You might get banned from her kitchen forever .

If you double the press fit Don you would be @ .496" bore.

Would Teflon work for you Don?

Not trying to start a argument Keith, Just looking for the best. The last time I mixed em was on 75MHZ FM. Digital on HT steering and analog on throttle, Haven't tried mixing on 2.4 yet. Ray, I have heard the digitals draw more juice.

I think Bob got it right as long as the Tx. is in the ppm mode Nothing evil will happen.

NIMH, The problems with analog servos is some company's have stopped producing them. I have mixed analog and digital before without evil results.

Looking for some honest opinions on 1/8 scale servos. I would like to use the Airtonics 94851 MG digital on steering and the Futaba 3102 micro MG analog on the throttle. Both servos will be brand new and mix will be controlled with the 9B manual needle. Let me know what you think. Thanks, Glenn

Metal, Never go into combat without it . Last month I sent a P.M. to Bill Brant(All RC on this forum). He was selling a couple different brands of servos(he is a dealer), I asked what was the best- not the cheapest. He recommended the Airtronics 94851 MG to replace my ageing 94358 MG Analog...

Ray, I have had a lot of the 9B carbs but none had a set screw on the high speed needle- perhaps someone added it.

There are only three ways to make the scale class bigger that I know of Robert. Buy one, build one or trick Rick into making one for you.

Thanks Don, Say Mikey and Steve Ball for the help finding this boat. Nice to know I have some good friends keeping a eye out for something really nice. Appreciate your advice!!!!!!!!!!!

Larry Gempp's 67 Bardahl.

found one

Right now I'm using the HT 645 MG but plan on trying one of the new Airtronics 192 Oz. Digital MG Std. size servos. #94851. Could be overkill but better to be the hammer than the nail. Bill Brant is a dealer(all rc) on this site.

I've only seen that happen once Scott and it was kind of a freak thing. The Cal Craft stuffed pretty hard and displayed the same behavior. Speed up in the turns and slow on the straights. When she dunked the wood screws holding the radio box in place(fore and aft) bent and would allow the radio...

Best case scenario is have a motor that can be pulled and replaced quickly. I'll send a P.M. Michael

Scott, The Virginia Craftsman fin and Speed Master hardware and strut are fine items to the best of my knowledge but rudders and props may vary depending on the brand of hull.