Parts For Sale Zenoah mod cases for sale

[TJ Hammons]

Hi guys,

For sale are 12 sets of modified zenoah cases. These are listed elsewhere. (5 sets remain as of 6/29/24)

Price is $25 per case set plus the ride or if you buy 2 case sets (or more) the price is $20 per case set plus the ride.

PayPal F&F, or add 3.5% for G&S, cashiers check or money order.

Shipping to the lower 48 only.

Thanks!
-TJ

 

[LeeWininger]

What's the difference/benefit of a modded case over a stock one?

 

[TJ Hammons]

What's the difference/benefit of a modded case over a stock one?

Lee, most of the cases above have been modded to support a 3rd bearing, (lubrication port in the larger case half) aside from that, they are ground for flow. However, you don't have to run a third bearing if you don't want to!

 

[Alan Elzer]

Hi guys,

For sale are 12 sets of modified zenoah cases.

Price is $25 per case set plus the ride or if you buy 2 case sets (or more) the price is $20 per case set plus the ride.

PayPal F&F, or add 3.5% for G&S, cashiers check or money order.

Shipping to the lower 48 only.

Thanks!
-TJ

Tim I'll take a set. What's your ppl ?

 

[TJ Hammons]

Tim I'll take a set. What's your ppl ?

You got it Al! I'll pm ya shortly.

Thanks!

 

[Alan Elzer]

You got it Al! I'll pm ya shortly.

Thanks!

Funds sent.

 

[dr gary turner]

I will take one
Gary Turner
3509 South Woodridge Road
Mountain Brook Al
35223

PM me your address and total $ and I will send a check. Thanks

 

[douglong]

I'll take a set, send me your ppl address.

 

[XtremeRcBoats]

Lee, most of the cases above have been modded to support a 3rd bearing, (lubrication port in the larger case half) aside from that, they are ground for flow. However, you don't have to run a third bearing if you don't want to!

Troy can you tell me which bearing do you use on that side?

 

[Troy Hammons]

6801-2RS is what goes in the M&D 3rd bearing seal.

Troy can you tell me which bearing do you use on that side?

 

[XtremeRcBoats]

Thanks Troy. Do you remove the inner seal of 3rd bearing and what size hole do you drill?
Did you find any improvements compared to the normal black seal?

(sorry for hi-jacking the topic).