WTB

[anthony_marquart]

trying to piece together a .12 rigger for my son. Looking for various parts like mini servos like hs81's or similar, mini servo mnts, small hardware, 1/4-28 to 0.15 collet... Whatever you might have laying around that your not using that might fit.

thanks for your help..

 

[ek kustomz]

I have a collet Tony.

pm me,

Zach

 

[Sean Bowf]

trying to piece together a .12 rigger for my son. Looking for various parts like mini servos like hs81's or similar, mini servo mnts, small hardware, 1/4-28 to 0.15 collet... Whatever you might have laying around that your not using that might fit.
thanks for your help..

Curious, what engine are you going to be putting in the .12 rigger?? A 1/4 x 28 crank shaft sounds like a pretty big engine...

Sean

 

[gooycheese]

I thought the same thing, what .12 has a 1/4-28 thread? All the .12 / .15 / .18's I have are 5mm.

Paul

 

[ek kustomz]

Hmmmm I may have to look. I think Iit may be 5 not sure though. Tony that cable is too short.

 

[anthony_marquart]

The .12 engines with the SG shaft are 1/4-28 thread. The off road style .12s are usually 5mm. The off road engines are usually set up for mid RPM range power. On road cars are ussually setup to run high RPM. That's why I'm going with the SG, 1/4-20 shaft. I'll probably end up running wire drive too.