WTB Picco 67 Crank

[Roxyflash]

Mine broke i have some other ones but there not the same.The one i need takes a 15 mm shaft for thebearings and the drive pin for the disk rotor is a tad under 4mm.Heres a picture.

http://i176.photobucket.com/albums/w165/Ro...sh/IMG_1592.jpg

 

[Joe Warren]

Mine broke i have some other ones but there not the same.The one i need takes a 15 mm shaft for thebearings and the drive pin for the disk rotor is a tad under 4mm.Heres a picture.http://i176.photobucket.com/albums/w165/Ro...sh/IMG_1592.jpg

What size is the small end of the shaft for the front brg (small brg)? I might have what you need.

 

[Joe Wiebelhaus]

Mine broke i have some other ones but there not the same.The one i need takes a 15 mm shaft for thebearings and the drive pin for the disk rotor is a tad under 4mm.Heres a picture.http://i176.photobucket.com/albums/w165/Ro...sh/IMG_1592.jpg

Oh yes, the old flywheel cone worn out, the unbalanced collet end goes snap............

Confused, your title says 67 crank, but that sure looks like a 45 crank ??

Post picture of engine.........

 

[Joe Warren]

Mine broke i have some other ones but there not the same.The one i need takes a 15 mm shaft for thebearings and the drive pin for the disk rotor is a tad under 4mm.Heres a picture.http://i176.photobucket.com/albums/w165/Ro...sh/IMG_1592.jpg

What is the Small end size of the shaft 6 7 or 8 mm

 

[Roxyflash]

8MM