Whip .21, maybe not square... questions

[Mike Hughes]

Same problem still exists with the 1/8 pad. Now you are just putting more pressure on one side because it will be traping more air.

Mike

 

[Chris Wood]

look at it like this.. you are already invested in the thing.. finish it and see what happens.. worst off i till be is fire wood.. I have had several boats that got twisted over the yr and some where VERY VERY good boats.

chris

 

[ken turmon]

Well,.. Mark this up as a lesson learned.. I probably will sell it off on ebay... and won't say it's dead straight... Besides that twist,.. it's built amazingly well built... but yes.// built and sealed already...

Oh well...

Please tell me you are joking. Nothing cool about knowingly pawning off a bad hull on another fellow boater.

 

[anthony_marquart]

I would never mislead someone on a sale... I've been burned and set back a lot of $$ and don't want anyone else to have the same feeling... If I sell it I'll take a picture of the 1/8 in difference for sure...

 

[Roxyflash]

Take and cut the top deck off.Start at a seam with a utility knife and get it to separate.Then get a real thin putty knife make it razor sharp start working it to separate the top skin off.It can be done.After its off sand it to accept the new top skin.Get it flat on the table weigh it down.Now glue the top back on.Brian will sell you replacement skins.

 

[SayMikey]

You should be able to remove the deck with a heat gun.Just take your time

 

[wayne middlemiss]

if it was me i would finish the build run it see what it does ,you got nothing to loose on it, ive seen worse than that before.