What's everyone working on for 2016

[Bradley Maglinger]

Scott PM sent

 

[SayMikey]

New for 2016 sport 40 assembly time

 

[stuart cortis]

My Dr Toyota

soon full restoration

 

[stuart cortis]

My Dr Toyota

soon full restoration

 

[scott williamson]

53 inch gas powered mono

 

[scott williamson]

Should have posted this instead being a hydro forum. 1/6 scale.

 

[scott williamson]

Should have posted this instead being a hydro forum. 1/6 scale.

 

[wayne middlemiss]

Should have posted this instead being a hydro forum. 1/6 scale.

You have been busy

 

[David Ashcroft]

Scott is that a going to be a Miss excide?looks good thus far

.

 

[wayne middlemiss]

Scott is that a going to be a Miss excide?looks good thus far

.

Aussie endeavour

 

[David Ashcroft]

Great even better ..

 

[scott williamson]

Thanks David ,as Wayne said it is Aussie Endeavour. Here's another one im building. 1/6 scale inline twin paynpak.

 

[Hydro Junkie]

Scott, what are you using for an engine in that Pak? I'm presently redrawing a set of Newton 108 plans into a gas scale 78 Madison. I'm looking at a CMB 27 for an engine in it due to the size of the engine bay so your twin has me curious

 

[P THOMAS]

Finishing up my gas scale Miss US

 

[Tim Strange]

Looks good Phil!

Your driver looks quite happy that you got those blue stripes laid out!!!

 

[Ray Sametz]

Finally getting back to my M/L Sport 40, hope to have ready for Hobart. Working on radio box layout with Micro servos, it's tight. Steering servo will be a Savox waterproof. Everything is a figure as you go with this engine placement.

 

[DeanJohnson]

Hi Ray,

Who makes that motor mount? I'm in the process of building this hull right now - did you reinforce the floor under the mounts?

 

[scott williamson]

Scott, what are you using for an engine in that Pak? I'm presently redrawing a set of Newton 108 plans into a gas scale 78 Madison. I'm looking at a CMB 27 for an engine in it due to the size of the engine bay so your twin has me curious

Gday Mark , im using an RCMK bottom end with modified zenoah cylinders.

 

[Ray Sametz]

Hi Ray,

Who makes that motor mount? I'm in the process of building this hull right now - did you reinforce the floor under the mounts?

Motor mount is Speedmaster with reversed 2' alum. angle. Reinforced the floor from under side of boat.