Twin radio bx

[John Seybold]

Hi,

I'm getting ready to finish my twin rigger and have a question about how to setup the throttle linkage. Do most people use two servos or one servo for the throttle? If using just one, can someone post some pictures of their setup.

Thanks for any help,

John

 

[Neil LaGarry]

Tower hobby you will need a 5/32 solid brass rod with 3 steering arms LXD 847 and LXD 841 straps to hold down your cut to fit brass rod 2 arms go to carb arm 1 to servo arm. all on 1 page Landing gear accessories if you want 1/8" brass rod then size down

http://www3.towerhobbies.com/cgi-bin/wti0093p?&C=QDZ

 

[Ray Sametz]

Don F twin

 

[Samuel Hagan JR]

Don F twin

What the dual receiver for, I have a twin I'm working on and would like to know also.

 

[shoboat]

Sam,

One for the steering and one for the throttle and mixture control.

Safety first with a 80+ MPH twin.

Don makes beautiful boats.

Mark Sholund

 

[Craig Knight]

I like to put steering and mixture on one and throttle on other. If you loose throttle you can still steer and richen it right up and if you loose steering you can shut it down.

 

[Elias Vazquez]

Don F twin

By any chance could you tell me who makes, or where to obtain those pushrod seals.

Thanks in advance,

Elias

 

[Ray Sametz]

Don F twin

By any chance could you tell me who makes, or where to obtain those pushrod seals.

Thanks in advance,

Elias

Prather used too, you can get them from Hyperformance Products 2-56 and 4-40

 

[Mark Bullard]

Here is a picture of throttle and mixture control. The center rods are the throttle and the outboard are the mixture control.

 

[thomaselkins]

try looking at the helo mixing arms for this setup, they wont strip