- Joined
- May 13, 2021
- Messages
- 11
Has any one had a Spektrum SR 6100 AT Receiver failure. ? I have them in my gas boats.
The Receiver quit functioning. The internal led light stated to go dim and and then completely went out. No response from transmitter inputs.
I have checked all the wiring harness from the fully charged receiver battery pack to the receiver. Did not find a problem. such as loose or bad wire .
I have checked the on off switch. It was also OK.
I finally tried just plugging in the battery pack to the receiver. The receiver is dead a a door nail. No Led light at all. It seems that the receiver has totally failed.
The receiver is in the water tight radio box , and has not gotten wet. The receiver is secured in the radio box with the double sided tape and is secure.
I am begining to think that the boat and engine vibration may be causing the problem were the receiver is failing because it can't take the vibrations causing the failure.
This is a bad situation if the receiver fails while the boat is running at speed. Because when the receiver fails , the fail safe is lost due to lose of battery power to the receiver, the servos will not move to there lose of signal position and shut the boat down.
Luckily this failure happened to me while the boat was being started. Every thing was working fine, then then receiver would not respond to any transmitter inputs. At that time I noticed that the Receiver Led light became very dim and then went out as if the power was shut off.
I am getting a new receiver and will put it on a soft foam pad and hope that will eliminate the vibration.
These receivers cost $100.00.
This is not a new receiver and has been in the boat for a full season with out a problem until now.
Thanks for reading this.
John
The Receiver quit functioning. The internal led light stated to go dim and and then completely went out. No response from transmitter inputs.
I have checked all the wiring harness from the fully charged receiver battery pack to the receiver. Did not find a problem. such as loose or bad wire .
I have checked the on off switch. It was also OK.
I finally tried just plugging in the battery pack to the receiver. The receiver is dead a a door nail. No Led light at all. It seems that the receiver has totally failed.
The receiver is in the water tight radio box , and has not gotten wet. The receiver is secured in the radio box with the double sided tape and is secure.
I am begining to think that the boat and engine vibration may be causing the problem were the receiver is failing because it can't take the vibrations causing the failure.
This is a bad situation if the receiver fails while the boat is running at speed. Because when the receiver fails , the fail safe is lost due to lose of battery power to the receiver, the servos will not move to there lose of signal position and shut the boat down.
Luckily this failure happened to me while the boat was being started. Every thing was working fine, then then receiver would not respond to any transmitter inputs. At that time I noticed that the Receiver Led light became very dim and then went out as if the power was shut off.
I am getting a new receiver and will put it on a soft foam pad and hope that will eliminate the vibration.
These receivers cost $100.00.
This is not a new receiver and has been in the boat for a full season with out a problem until now.
Thanks for reading this.
John