Seaducer 44 Gasser Mono

[TomGracey]

Just started a Gas Mono build, this will be run in a restricted engine class in NAMBA District 8 the main reason is to keep down the cost. The only engine allowed is a totaly stock Zenoah G 260 PUM and only factory replacement parts can be used and any MONO hull that is covered under the NAMBA rules

So far most of the hardware has been installed just have to install the fuel bag and then on to the electronics
Spec's
Hull
Seaducer SD3 44" Gas
TNX for the fast delivery Jerry
Engine
Zenoah G 260 PUM with Zippkits Super Tuned Quite Pipe V3
Electronics
Futaba 4GRS RX/TX
Savox Waterproof Servos

 

[john v]

bob austin has the right prop for that boat

 

[TomGracey]

An

bob austin has the right prop for that boat

His Contact info Please

 

[TomGracey]

The mock-up done time to break it down clean it up (have to clean the shop first ) then add some flotation button up the fuel/water lines and do the final assembly.

Unfortunately it's fall in Western Wa. so getting some descent wx to go play with it will be iffy

 

[john v]

[email protected] 99% of my props come from bob and there is a reason why

 

[rhomodel]

The cooling cap doesn't look stock to me, or is that part of the fitting process, not the final engine?

 

[FloridaScaleBoater]

The cooling cap doesn't look stock to me, or is that part of the fitting process, not the final engine?

The rules allow you to polish, paint, anodize the cooling cap any color you like.

 

[David Bryant]

that's a nice looking boat there Tom. I'm sure it will be fast! (at only 44")