Rossi .65

[john schultheis]

Hi just wondering if anyone can tell me where i can find parts for a rossi .65 inboard Thanks

 

[Glenn Quarles]

Hi just wondering if anyone can tell me where i can find parts for a rossi .65 inboard Thanks

John, I have a few parts...give me a call at 210 392-2271.

Glenn

 

[Geraghty]

Glenn,

You can also add this to your roladex for Rossi parts......they don't have everything but they do have some.......

http://shop.vendio.com/RossiEnginesUSA/home.html

 

[john schultheis]

thanks glenn i tried calling you but i got no answer i need the rubber piece that seals the exhaust header to the exhaust port on the motor it has a water cooled header

 

[Glenn Quarles]

thanks glenn i tried calling you but i got no answer i need the rubber piece that seals the exhaust header to the exhaust port on the motor it has a water cooled header

John, I guess I was either on the phone or out in the shop...sorry. I just looked, but don't have any of the exhaust orings. I would think those would be easy enough to find or you may be able to make sue with the right size pipe coupler material and some careful cutting. I do have some bearings, rods, and misc orings.

Glenn

 

[Tom Foley]

thanks glenn i tried calling you but i got no answer i need the rubber piece that seals the exhaust header to the exhaust port on the motor it has a water cooled header

John, I guess I was either on the phone or out in the shop...sorry. I just looked, but don't have any of the exhaust orings. I would think those would be easy enough to find or you may be able to make sue with the right size pipe coupler material and some careful cutting. I do have some bearings, rods, and misc orings.

Glenn

I made some mandrels the size of the exhaust spigots on the engines and use a home-ground tool bit with lots of undercut.Then turn on the lathe and make my own fron the good silicone coupler material that Tim Jones sells . Just cut a little , test fit the header until you get a nice fit then make up a dozen or so . Use a razor knife to part them and slide them off the mandrel .

 

[Martin Hamilton]

Hi just wondering if anyone can tell me where i can find parts for a rossi .65 inboard Thanks

If you cant find any seals in the US send me you address & ill put a couple in the post to you, their be coming from the UK so allow extra time on shipping. I dont want anything for them just glad to help out, their unused buy the way. Regards Martin.

 

[Martin Hamilton]

It looks like the place Rod Geraghty suggests might be suitable part number 2312 @ $3.50. If not let me know. Martin.

 

[carlnoki]

John;

I have a complete Rossi 65 with new crank, bearings and P/L.

100.00 takes it.

 

[Bob Kensill]

I have a few of the Rossi exhaust seals. PM me your address and I will send them.