RCboatcompany.com /Steve G - 1/8 scale Carbon Rear Wing Set (Bud style for 1990s & up)

[nicholashansen]

Steve Gualtieri (rcboatcompany.com scale hydros) manufactured rear wing set, all carbon fiber, made for modern style turbine boats, about 1990 and up (a few older Bud boats may have had this style pre-1990s as well).

The uprights have been joined and high density pink foam was epoxied inside, however they are far from finished and the seams need to be filled in and the bond strengthened, they could easily be separated if desired with a little dremel work or lacquer thinner, etc. The horizontal is in two pieces and needs trimming and assembly, I can include a little more high density foam for flotation if you would like. All pieces are full carbon fiber and epoxy construction.

55$ USD plus shipping

 

[KenOlvis]

Will these work on the Atlas van lines year 2001 2002

 

[nicholashansen]

Correct me if im wrong, but I thought 1982 was the final year for Atlas Van Lines in H1??

either way, I dont believe these wings would not work with any respective Atlas boats. Those boats I believe had Lucero style wings, in that the half round indentation on the bottom of the uprights in the wings im selling, are not present.

 

[KenOlvis]

My mistake it was 82-83.

 

[Hydro Junkie]

Nicholas is correct, these verticals are not correct for either the 7701 or the 8200 Atlas hulls. Here's a shot that shows the verticals on the 7701:

http://api.ning.com/files/q4e7MPg*s4PegVJ9PvUmQzPpB1BDAagSjrZBhvgsSv6qvsaHT*VarEj52SEPyV6cAJ6w41qM-fA1fWmW*S8Cpf0ZvLzeN2E6/1978ATLASVANLINESTRICITIES.jpg

The verticals on the 8200 were from the same molds as what was used on the 7701, as was the engine cover. Just a little FYI