PT Stealth 45 Sport 40 Build

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
ZOOM ZOOM..

Make me want to have a Sheath LOL.. (my boat is now 13 years old Phil!) Yes 13.. she looks as good a new! I guess untill the thing get cut in half.. she will keep strolling!
 

Attachments

  • Stuff (4).JPG
    Stuff (4).JPG
    304.1 KB
The fun part of build cutting the slot with out making it sloppy fitting.I chuck a drill bit in collect on motor then cut three pieces of tubing stepped up to use a guide about 4 inches long I drill a hole about mid way of slot then angle the drill to make the slot then rat tail file for final fit.
 
the hull slot is marked on these boats, I would drill a 5/16 hole on each end and cut between holes, enlarge slot as needed. You should use the brass bushing in the front of 1/4 tube to center the cable in the collet for nice alignment.
 
ZOOM ZOOM..

Make me want to have a Sheath LOL.. (my boat is now 13 years old Phil!) Yes 13.. she looks as good a new! I guess untill the thing get cut in half.. she will keep strolling!
OK Z Dawg,,
I have you beat.
My strut template for my Corona Xtra is dated 6/13/2005 19 years.
And I bought it second hand from John Pinkerton.
Damn good boat.
 

Attachments

  • 20240220_192053.jpg
    20240220_192053.jpg
    3.3 MB
Drive line installed next up is the radio box.

Big thank you to Grimracer and Bradley Maglinger for the advice on strut tube installation.
 

Attachments

  • 20240330_153210.jpg
    20240330_153210.jpg
    969 KB
Last edited:
Servo mounts installed radio load blocks installed along with fuel tank.
Next up remote needle valve and Servo linkages. Getting close to being ready for paint.
 

Attachments

  • 20240403_153140.jpg
    20240403_153140.jpg
    2.9 MB
Back
Top