45 Picco Blackhead Pistons and sleeves.
I haven't seen or heard from you guys (Jason & Steve Pas) in along time and its nice to see your still around. Well you may not get alot of people posting on here but the interest is very high if you can deliver. As for what is needed, that would be what you listed and the 80 EXR, MAC 84 too. If you had them in stock today you would sell out before the
Great idea. Parts for these engines seem to be in great demand. Good luck to you. Richard D
Eric is looking for the 95-99 series to be more specific.
I mentioned this before in a post to Andy Brown, if someone made piston/sleeves, rods, head buttons, crankshafts at a minimum, there are hundreds of half engines laying around.
Do you have the titanium rods for the Picco 67 EXR now?
This is the way to go. All we need is cranks rods and Liner/pistons. Now I am sure we can find cases???
Eric I have 1 - New PICCO 45 BLUE HEAD P/S for sale if that is the engine you are running???? $75.00 plus 3.00 shipping USPS. This paticular 45 p/s is extremely hard to find..... jw. Jason if you guys make P/L for PICCO EXR`s the 45 67 & 80 would sell fast. Many of the aftermarket rods were very good quality. Most copied a problem even the RPM rod & the stk Picco had. Not enough rod side clearence on the crank pin. I have clearenced the Rpm Rods & they last forever 150-200 rounds of racing. Also the radius on the large end bushing has to be countersunk. That way the radius on the crank pin never sees the bushing. Many of factory Picco problems have been correctly after they left the factory & Many are on the water today still racing Hard. jw.
Jason, I think that we do need another line of engines. The Picco motors especialy the 45's were and are great. I would be vary supportive of the effort. I have about 3 or 4 new Picco 45,s left and would like more and especially P/S. also the 67 would be vary successful. Gary "DOC"
