Olly's new CMB RS 45 powered Seaducer.

[Terry Keeley]

 

[David Ashcroft]

Going well Olly is that a 50903 pipe?

 

[Olly]

It's a OPS 60 pipe

 

[DickJones]

OLLY
Dick Jones here, Good to see U testing your boat, How is Marissa doing, Sue and I miss seeing your group from way up in the cold country, first time I have been on the I Waters site in a long time, I hope to make it to a race this year, I need to get one of my, Andy brown, SG, 80 rigger out, and try to get the rust of the boat, hope to see your group some time this summer, I will be in the hospital in Tampa, General for most of June and July, and then start boating again. Tell everyone hello!!!!QQ
Sue and Dick Jones.
BTW if any one wants to see the Video, of my, AB, 80, Eagle SG, just send me a email and I will send it to U, only,1 minute long.

 

[Terry Keeley]

Hope you're doing better Dick...

 

[Jerry_Crowther]

Looks Great Olly Can't wait to race you in a few weeks.

 

[timothy johnson]

Very nice boat Olly, have you settled on pipe prop combination yet? Have you tried a CMB nitro pipe? Does the OPS pipe fit over the CMB header> Thanks.

 

[normlee]

How did you go with the engine clearing the drop mounts?

 

[Olly]

Very nice boat Olly, have you settled on pipe prop combination yet? Have you tried a CMB nitro pipe? Does the OPS pipe fit over the CMB header> Thanks.

I have not tried the cmb pipe but do like the Ops pipe and it will fit over the Cmb header with a little coaxing

 

[Olly]

I have not tried the cmb pipe but do like the Ops pipe and it will fit over the Cmb header with a little coaxing

As for the prop, I am using the octura x450/3 blade and the abc 19-14 /3 blade works well too.

 

[timothy johnson]

Thanks Olly

 

[Olly]

How did you go with the engine clearing the drop mounts?

Hi, all I did was machine the outer rails to make the motor fit.

 

[timothy johnson]

Olly are using the lower cooling on your RS or just the top.

 

[Olly]

Yes I am using the lower cooling ring .

 

[GraysonTaylor]

Last week I was looking at my OPS 67 muffled pipe and was thinking tail seemed kind of small. So I dug out my Prather 45 nitro pipe with a Prather after muffler. The header diameter, long taper and cone diameter are all the same. This left me scratching my head. I was wondering if I could run my 45 pipe on my 67. Well, Olly has a great running 45 running a 67 pipe. Can anybody provide some background to this?

 

[timothy johnson]

Anybody know where to buy the OPS 60 pipe ?

 

[timothy johnson]

Yes I am using the lower cooling ring .

Thanks Olly, will a 10 degree header work or would the 15 be better?

 

[Olly]

15 degrees is best for a mono.

 

[David Bryant]

Anybody know where to buy the OPS 60 pipe ?

message Max (c/o Mantua Model) on Facebook:
https://www.facebook.com/mantuamodelmodellismo/?epa=SEARCH_BOX