OK I give,.. I need help

[anthony_marquart]

I need someone to help me with a few odd parts.. I need a pipe mount bracket for a .21 rigger where the pipe mounts to the side of the tube, forward of the radio box in the engine compartment. I need it with 2 fasteners into the tub as I can't stop rotation with just one mount..

I also need a turn fin support rod made. Preferably aluminum, that either has a threaded stud on the end or can be threaded into the end. I need it the same dia as the boom tubes from ZIPP. Of course I'll pay you for your work...

Please help!!!!

Beached...

 

[ww29]

for the pipe mount u can use a piece of flat brass 1/16 inch thick and 1/4 inch wide it is easy to do your self you can roll it around the end of your pipe to get proper fit. just leave a little over hang so u can drill a hole threw and use a nut and bolt to hold it tight. then drill threw other end and into your hull and use nut and bolt to secure it to hull. hope this helps you

contact mike hughes on here for turn fin

 

[anthony_marquart]

I have a similar set up with a "P" clamp,.. can't keep it from turning...

for the pipe mount u can use a piece of flat brass 1/16 inch thick and 1/4 inch wide it is easy to do your self you can roll it around the end of your pipe to get proper fit. just leave a little over hang so u can drill a hole threw and use a nut and bolt to hold it tight. then drill threw other end and into your hull and use nut and bolt to secure it to hull. hope this helps you

contact mike hughes on here for turn fin

 

[Mike Hughes]

Got any pics of your setup right now. The aluminum support is easy to do. Best if the end of the bar are tapped instead of a stud. The aluminum is weak in a 4 size. Why do you want it the size of the zip tubes? For the pipe. If you use the clamps that are metal with rubber wrap you can add a little piece of brass in between the bolt hole section that runs out to the tip of the pipe. Put a pipe clamp around the stinger and brass and it wont move.

Mike

PS I think P clamp is what I am talking about above.

 

[Mike Hughes]

So I was able to build you what you wanted. It is 11.5" long. I made a few extra additions that will make it have better support for the turn fin. No extra charge.



Should go in the mail tomorrow or friday. Get back with me on the other part when I get back.

Mike

 

[anthony_marquart]

That is sweet!!! Thanks and can't wait to get it!!!!!

So I was able to build you what you wanted. It is 11.5" long. I made a few extra additions that will make it have better support for the turn fin. No extra charge.

View attachment 28063

Should go in the mail tomorrow or friday. Get back with me on the other part when I get back.

Mike