- Joined
- Mar 11, 2002
- Messages
- 4,393
Hey,
I have some FE equipment I need to clear out for a 12 cell OPC project I am planning for…can split, but it depends on which item it is I suppose. Or Trade for 12 cell OPC gear too!
-Kyosho Dolphin OB, with a 16/3 turn arm in a D4 can…pics of this OB setup can be found at http://www.rumrunnerracing.com/fefo...20&pagenumber=3 bearings are also installed in the shaft and cable is almost new (not many runs on it)…adds up to a cost of at least $200aud
-I think it has an X638 cut down to 35mm (cant remember what original prop was, but the pitch was not changed, just diam reduced) $40aud
-2 6 cell ‘stick’ packs – one is a 1400mAh (Tamiya pack) and other is 1700mAh (Sanyo cells)..paid about $70aud for both a little while back (maybe 1 ¾ years ago)
-Novak tempest III ESC, originally bought from AndrewG and haven’t used it very much (maybe 6 times) also just had a repair because something went wrong…but it is all good now…paid about $140aud including repair
-Pro Peak 300 charger which is only good for 6 cells at a set 3A charge rate…paid $45aud a couple of months ago, still in A-1 condition
-Tunnel hull is of my own design (balsa wood) coated with Aircraft dope to seal it, and runs pretty good...it is different from the one in the pictures and has a nice self made cowl from f/glass (finishing resin and 2-3 layers of ¾ ounce glass)…materials to build cost of at least $50aud
I understand the prices I stated are well away from what I will get for them, but I just wanted to state they were worth new. This will basically come with everything needed to get it to run (incl. standard servo for steering) steering cables, all connectors and wires (13awg) are DEANS except Rx and Tx…but a Futaba Rx and a Sanwa Dash Saber stick Radio can be added if needed.
So, I am not sure what all of this stuff is worth but am hoping to get about $300AUD ($192USD) for all of it...but i can be bargained down of course
I am in Aus, but am willing to post anywhere in the world! Email, PM or post here if interested.
Thanks for looking
Kris
PS i know i have posted this on a few forums, but it just needs to go ASAP
I have some FE equipment I need to clear out for a 12 cell OPC project I am planning for…can split, but it depends on which item it is I suppose. Or Trade for 12 cell OPC gear too!
-Kyosho Dolphin OB, with a 16/3 turn arm in a D4 can…pics of this OB setup can be found at http://www.rumrunnerracing.com/fefo...20&pagenumber=3 bearings are also installed in the shaft and cable is almost new (not many runs on it)…adds up to a cost of at least $200aud
-I think it has an X638 cut down to 35mm (cant remember what original prop was, but the pitch was not changed, just diam reduced) $40aud
-2 6 cell ‘stick’ packs – one is a 1400mAh (Tamiya pack) and other is 1700mAh (Sanyo cells)..paid about $70aud for both a little while back (maybe 1 ¾ years ago)
-Novak tempest III ESC, originally bought from AndrewG and haven’t used it very much (maybe 6 times) also just had a repair because something went wrong…but it is all good now…paid about $140aud including repair
-Pro Peak 300 charger which is only good for 6 cells at a set 3A charge rate…paid $45aud a couple of months ago, still in A-1 condition
-Tunnel hull is of my own design (balsa wood) coated with Aircraft dope to seal it, and runs pretty good...it is different from the one in the pictures and has a nice self made cowl from f/glass (finishing resin and 2-3 layers of ¾ ounce glass)…materials to build cost of at least $50aud
I understand the prices I stated are well away from what I will get for them, but I just wanted to state they were worth new. This will basically come with everything needed to get it to run (incl. standard servo for steering) steering cables, all connectors and wires (13awg) are DEANS except Rx and Tx…but a Futaba Rx and a Sanwa Dash Saber stick Radio can be added if needed.
So, I am not sure what all of this stuff is worth but am hoping to get about $300AUD ($192USD) for all of it...but i can be bargained down of course
I am in Aus, but am willing to post anywhere in the world! Email, PM or post here if interested.
Thanks for looking
Kris
PS i know i have posted this on a few forums, but it just needs to go ASAP
