J.A.E 45 GT Kit boat Basic dimensions FWIW

[Ron Zaker Jr]

Transom to engine C/L 19.5 inches
Rudder (no taper L.E.) 2-5/8 below ski
Pipe 9.5 ish
Rudder L.E 2-1/2" from transom
Toe in 1/8"
Tub Offset outside 9" Inside 8-3/4 (to the right top view)
Strut flat /.1-.2 degrees neg
ABC 2317 bag prop.
0-80 or -2-56 pin on rear boom inside tub
CD Machine turn fin /mounting screws go ALL THE WAY THRU SPONSON add G-10 plate to sponson outside where screws heads are.

Hope this helps on your build.

 

[P THOMAS]

I have the kit I won in Internats raffle, Thanks Zipp.
I order the parts to complete the build. I will work on it next year.

 

[Rich Junker]

Transom to engine C/L 19.5 inches
Rudder (no taper L.E.) 2-5/8 below ski
Pipe 9.5 ish
Rudder L.E 2-1/2" from transom
Toe in 1/8"
Tub Offset outside 9" Inside 8-3/4 (to the right top view)
Strut flat /.1-.2 degrees neg
ABC 2317 bag prop.
0-80 or -2-56 pin on rear boom inside tub
CD Machine turn fin /mounting screws go ALL THE WAY THRU SPONSON add G-10 plate to sponson outside where screws heads are.

Hope this helps on your build.

If your not using the Zipp/JAE strut, is the front of the drive dog even with the trailing edge of the rudder a good setup?
Thanks for all the info.

 

[Ron Zaker Jr]

If your not using the Zipp/JAE strut, is the front of the drive dog even with the trailing edge of the rudder a good setup?
Thanks for all the info.

 

[Ron Zaker Jr]

yes will be fine

 

[Rich Junker]

yes will be fine

Thanks Ron.

 

[Ron Zaker Jr]

Thanks Ron.

very welcome ,any questions just contact me.