How to use plastigauge for measuring head clearance

[Terry Keeley]

I've been using 0.016" solder for years with a mic to measure it, it repeats every time, just bend a bit and stick it in the glow plug hole.

It takes all the slack out of the rod/wrist pin/crank just as it is while the engine is running, I run 0.012" for everything up to my 90's which I run at 0.014".

https://www.amazon.ca/AmaoeTin-Electrical-Soldering-Content-Melting/dp/B09WYQ8W9W

Flame away.

 

[XtremeRcBoats]

I've been using 0.016" solder for years with a mic to measure it, it repeats every time, just bend a bit and stick it in the glow plug hole.

It takes all the slack out of the rod/wrist pin/crank just as it is while the engine is running, I run 0.012" for everything up to my 90's which I run at 0.014".

https://www.amazon.ca/AmaoeTin-Electrical-Soldering-Content-Melting/dp/B09WYQ8W9W

Flame away.

Thanks Terry, this is for the K&B67 project. Tried you head button today and first need shims. I found a 0,3mm shim in another K&B67 but before TDC the piston hits the button, so i first need to find some shims. Does anyone perhaps know if shims for other size engines can be used for this one?

Hi Daniel,

I have not seen a squish gauge in use or even photos of how they actually measure. But how do they account for dished/domed pistons and tapered head button squish?

I have just been using a digital vernier and also a digital depth gauge to get my numbers...it does not really account for dish and tapers...but in all honesty, it is how I have seen some REALLY FAST guys do it, so it must be ok

Hi Kris, can you tell me how this work?

How hard can it be!

Hi Timothy, Can you tell me how to do that with this tool?

 

[timothy johnson]

Thanks Terry, this is for the K&B67 project. Tried you head button today and first need shims. I found a 0,3mm shim in another K&B67 but before TDC the piston hits the button, so i first need to find some shims. Does anyone perhaps know if shims for other size engines can be used for this one?


Hi Kris, can you tell me how this work?


Hi Timothy, Can you tell me how to do that with this tool?

Daniel's racing in the vendor section sells the adapter and explains its use. Rossi sales, Speedmaster, also sells an adapter.
In short you first install the adapter in your removed head button and zero it out on a flat surface. You then install your head button on your engine and move the piston to TDC and then read the difference from zero to the top of the piston.