flywheel and collet for engine with m4 threads

[TomMoorehouse]

Anybody have a flywheel and collet that will work with an engine with m4 threads? This would likely be .098 flex shaft possibly wire drive.

This is for a special baby rigger project I've always wanted to do. I've got a nice .09 engine and tuned pipe.

 

[seaducerpete]

Tom try Gary Preusse if anybody would have it he would

 

[Ron Olson]

It's too bad that you need an M4 collet as I've got an M5 with a cable in .98". If it was a mono that you were going to build, I also have a strut, rudder and some props.

 

[Mike Larson]

Tom.. call Gary... he had the one for my engine, ( it was serious old school, but, a nice collet)... he may be able to dig in his stuff and getcha another... mine went out when i give my boat away.... sorry man.... Mike