Parts Wanted Floor Type Motor Mount

[rctinman]

Does anyone recognize this floor type motor mount? Who made them? Are they still available? Does anyone have a new set they would like to sell? Not interested in anything but this exact item.

Thanks for any help or info!
Steve Ball

 

[SayMikey]

Mike Hughes mount im pretty sure

 

[rctinman]

Mike Hughes mount im pretty sure

That would be great if it was!

Thanks!
Steve

 

[Mark Anderson]

No way that is one of Mike's.

 

[ALLAN YUEN]

Contact to James “Gabe” Clegg. he can make one by CNC machine Good Luck!

 

[Mike Hughes]

Not mine.

 

[rctinman]

Not mine.

Didn't figure they were. Thanks Mike!

Steve

 

[mrgary]

at one time I thought Kevin Sheren was selling them

 

[rctinman]

at one time I thought Kevin Sheren was selling them

Kevin's were different.

 

[mrgary]

ok, was not sure, sorry

 

[BrianNeumann]

Swear I saw Bill Brandt selling similar style engine mounts on his website? I don’t recall the engines sizes, but they were floor mount engine mounts. I think the website is called allrc1 or rattlesnakerc? I hope that helps & you find them Steve!
Brian Neumann

 

[rctinman]

Swear I saw Bill Brandt selling similar style engine mounts on his website? I don’t recall the engines sizes, but they were floor mount engine mounts. I think the website is called allrc1 or rattlesnakerc? I hope that helps & you find them Steve!
Brian Neumann

I'll check it out. Thanks Brian!

Steve

 

[rctinman]

Over 400 views, and no one has ever seen these mounts. Someone went to a lot of trouble to write the program to carve these out!

Steve

 

[rctinman]

I'll check it out. Thanks Brian!

Steve

Bill's aren't close.

 

[Buckshot]

Over 400 views, and no one has ever seen these mounts. Someone went to a lot of trouble to write the program to carve these out!

Steve

These are super nice, someone’s got to know something.

 

[BrianNeumann]

Sorry about that, I was browsing the site months ago & going by memory. Someone has to know who made those and hook you up. Or tell Mike he’s grounded until he whips up a set on his 3D printer!!!
Brian Neumann

 

[Tom Foley]

You could make them rather quickly with a conventional mill and then do some hand work for the radiused sections around the isolators or just leave them square with rounded corners and mill out some weight underneath .

 

[Mike Hughes]

I can make you one if you strike out Steve. It would be hand cranked. No CNC in my shop. Might need one to measure.
Mike

 

[Rudy Formanek]

Made by Victor Gorecki. He made a few, didnt sell well. I might still have one will check later today

 

[rctinman]

Made by Victor Gorecki. He made a few, didnt sell well. I might still have one will check later today

Thanks for the info Rudy! If you do run across a set, I'd be interested!

Steve