Filament

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I have not... I have been using the Inland brand sold through MicroCenter stores. Primarily, because I pass the store on a daily basis.

I have also been printing in more PETG vs. PLA
 
thanks bud.. at 20 bucks a roll it might be worth a go.. (I-we have been using Hatchbox but am finding there must be supply issues going on) Our company is looking for a second source.

Grim

agreed, 20 bucks a roll is good value if it prints well. Their shipping costs are very reasonable. I my need to take a drive up there to check them out.
 
I like PLA... its just easy.. also.. PPLA is VERY nice.. Hatchbox sells it in a few colors. Having said this I would never use it in a high heat or high vibration area. These are ABS.. (Jet Exhaust for my 1/7th Bell 212.. (Before and after paint, made on an older Makerbot X2)
 

Attachments

  • i-6szjFRG-X4.jpg
    i-6szjFRG-X4.jpg
    328.3 KB
If anybody wants a VERY NICE working PLA setup for CURA and the CR10 just PM me.. I have a Super setup for PLA and can send you the setup. (you can import it into your preferences)

I also have one for Polymaker as well as Ninja Flex 85A

PM me is needed.

Grim
 
If anybody wants a VERY NICE working PLA setup for CURA and the CR10 just PM me.. I have a Super setup for PLA and can send you the setup. (you can import it into your preferences)

I also have one for Polymaker as well as Ninja Flex 85A

PM me is needed.

Grim
Grim:
If you could send me that file that would be great, I have a CR10 Smart.
 

Latest posts

Back
Top