engine mounts

[opio]

I was wondering where I might be able to get the "bushing" (I cant think of what there called) you know the rubber part, or what you guys use if you make your own. I have seen I guess there plastic of some sort bolts used a lot and would also like to know where to find something similar.

Thanks

 

[J Solinger]

I generaly use McMaster-Carr, mcmaster.com.

 

[opio]

thanks! Your hardware is very nice so it must be a good place to start lol!

 

[mark voorhies]

thanks! Your hardware is very nice so it must be a good place to start lol!

Look in vibration-sandwich mounts, let me know if you find somethin that will work.

http://www.mcmaster.com/#sandwich-mounts/=2blvvq

 

[Bob Howard]

If you are referring tonthis type of gromet, http://www.mcmaster.com/#rubber-grommets/=2bwcao I ordered some and recieved 50. If you just need 4 or 6 let me know your address and I will throw some in an envelope and send them to you no charge.

Bob

 

[opio]

Thanks! PM sent

 

[gooycheese]

I get nylon screws and spacers from Home Depot, I also get the grommets there. If mcmaster carr stuff is better i can go there, its just a will call item for me (less than 10 miles to mcmaster carr).

Paul

 

[Neil LaGarry]

you may want this type http://www.funrcboats.com/ProductInfo.aspx?productid=AER1882

 

[opio]

thanks for all the replies fella's!

 

[M. Stein]

McMaster carr has good quality isolators. I have bought cheaper ones and had a problem since the ceter line of the stud on one end and the hole on the other were not in line. When the mount was assebled the 2 sides were not at the same angle.