Engine Bearings

[Mike Betke]

Ok, i need 2 sets of #1 shipped to 32796, please.

PM sent

 

[Duke Mordja]

Mike
Do you have 4 sets of #3 Bearings for CMB67?
Shipped to 53168.

Thanks
Duke

 

[Mike Betke]

Mike
Do you have 4 sets of #3 Bearings for CMB67?
Shipped to 53168.

Thanks
Duke

Yes I do. Pm coming your way.

 

[Duke Mordja]

Bearings received. Thanks Mike!!

Duke

 

[longballlumber]

Hey Mike, can I get 2 sets for the 45 V5 and 2 sets for the 101 please?

 

[Grimracer]

yep...

 

[Mike Betke]

Hey Mike, can I get 2 sets for the 45 V5 and 2 sets for the 101 please?

Sure thing. PM incoming

 

[P THOMAS]

Need two set bearing for cmb beta 21 ane one set for cmb 45 V5

 

[Mike Betke]

Need two set bearing for cmb beta 21 ane one set for cmb 45 V5

I replied back to your PM. Thanks for the order.

 

[Stephen Roberge]

Mike, I need a set of #1 please.

 

[Richard Hartley]

Sent Pm with needs
Thank You

 

[Rc painter]

mike,will the 90/101 fit the older purple head evo's?

 

[Dave Gilles]

any sets for K&B?

 

[Mike Betke]

any sets for K&B?

Sorry, I do not have anything for K&B

 

[Mike Betke]

mike,will the 90/101 fit the older purple head evo's?

Larry,
I am not sure what the older purple head may have in them. Some had needle / ball bearing mix. Some had different size ball bearings. The best bet is to take your motor apart and measure the bearings, then I will be able to get you an answer.

Thanks,
Mike

 

[FloridaScaleBoater]

Mike,
Need the following:
2 sets #3 for CMB 67 hydro
2 sets #4 for CMB 45RS Red Head
Can I also get one of the large (front, flywheel side) bearings for the CMB 45RS red head.
Will PM you send to address.

 

[raceready]

mike , do you carry anything for NR 21?

 

[Alan Elzer]

Jon thibodeau will have them. [email protected]

 

[tnrcboatracer]

Thanks Alan, but i dont' want to step on Mikes Thread. I'll refresh my old post now that I'm retired.

Rick. I kave plenty of the 629 front bearings for the 45RS if Mike doesnt have that size.

I have a few bearings for the older NR21 14mm crank motors, 25mm case bore. The newer motors are all special sizes that cost me s fortune to get with 100pc minimum orders (if at all).

 

[Mike Betke]

mike , do you carry anything for NR 21?

I do not carry any NR bearings. You will need to be more specific with exactly which engine you have when looking for these as they take different sizes.