Eagle SGX w/ Hardware and MAC .67 (Sold Pending Funds)

[Bob Nauss]

I am looking to sell a brand new Eagle SGX with full Hardware and MAC .67 with AB .67 pipe for $1500

Eagle SGX kit that has been built

Full CMD hardware kit

Speedmaster tune pipe bracket

1 extra AB 1/4 “ flex shafts

ABC H-30 Prop 61.74 mm diameter and 5.29” of cup done by Props-4-U

MAC .67 that has only been out of the box when needed to build the boat

Extra front and rear bearings

2 extra exhaust header gaskets

4 extra back plate gaskets

Exhaust header

AB .67 Muffled Pipe (Silver) with full Stinger Bushing set.

Changes from the standard AB setup.

I have set up a 1/8” brass tube for the water line from the rudder to motor compartment

I have set up a Speedmaster Tune Pipe bracket

The Rudder control rod is 1/8” stainless steel rod with the ends threaded 4-40

Carbon Fiber cloth was used to reinforce the motor compartment under and in front of the motor

The cowl is secured in the back by (2) 1/8” stainless posts and Aeromarine Cowl Hold downs

Hull and sponsons have been sealed with West Systems Epoxy

Hull and sponsons need final sanding and painting

Please Note that I will not break kit up. I am selling this as complete kit.

Photos are in my gallery

My Gallery

 

[Buckshot]

Hello Bob,

If you change your mind, I'd like to buy the motor, and pipe.

-Buck-