toyotatruckin
Well-Known Member
- Joined
- Jun 5, 2006
- Messages
- 1,068
I have a couple of these blades form the machinist that cut some stock for a customer (left overs), as you can see in the picture the bottom needs cut off still and the pick-up tube needs pushed in the hole, less than 5 minutes of work, these are polished and SHARP and fit the stock miss vegas rudder bracket tested on a mod boat with an increase of 2-4mph over stock rudder. blade length is 2 2/8 L-- total length including bracket area is right about 3 1/4 L-- blade width is 1 3/32.
Not selling as a finished part if you would like a finished part contact sean burns here on inwaters, with that said unfinished price is 15$ EACH shipped in the US lower 48 paypal only.. thanks for looking
Not selling as a finished part if you would like a finished part contact sean burns here on inwaters, with that said unfinished price is 15$ EACH shipped in the US lower 48 paypal only.. thanks for looking
Last edited by a moderator:
