To start with:dion26 said:hey every 1 i just got a wof 30 with a cmb 3.5 on it and i took it out 2 day and it just dont seem like it wants 2 go any help plz needle settings engine hight any thing thanks guys later dion
106465[/snapback]
ok ill try that i got a X438 would that b a good prop 2 usePulsetech said:Dion Lift the engine to reduce load try another 5mm for starterstry going down a prop size ie. x437 p215
Im not familiar with the spp but try it longer just in case
do you have a header tank installed
106470[/snapback]
na i dont but i can make 1cjm102 said:Do you have a setup board to accurately measure the prop shaft height?
106482[/snapback]
good idea!dion26 said:na i dont but i can make 1cjm102 said:Do you have a setup board to accurately measure the prop shaft height?
106482[/snapback]
106483[/snapback]
wots neutral trimcjm102 said:good idea!dion26 said:na i dont but i can make 1cjm102 said:Do you have a setup board to accurately measure the prop shaft height?
106482[/snapback]
106483[/snapback]
Also run neutral trim.
Chris
106484[/snapback]
so wot its dead straight is that wot u mean yacjm102 said:neutral trim: no angle of the eng.
Chris
106486[/snapback]
YEP!dion26 said:so wot its dead straight is that wot u mean yacjm102 said:neutral trim: no angle of the eng.
Chris
106486[/snapback]
106487[/snapback]
Enter your email address to join: