All rattle can Zippkits G30 nitro tunnel!

[Bill Gibson]

I may regret this but i just did this G30 in Rustoleum orange and will do the orange cowl with Spraymax 2K clear after it dries for 5 or so days! The hull was sealed with finishing epoxy resin and then cleared with Spraymax 2K clear! Ive had better finishes, but i dont think that it looks too bad......either way its going to the Internats!!!!

 

[Roxyflash]

The orange layed down nice.Looks good a little orange peal don’t hurt some new cars have that effect.

 

[Bill Gibson]

The orange layed down nice.Looks good a little orange peal don’t hurt some new cars have that effect.

Thanks Bruce! After a week im going to wet sand the cowl and clear it! Canned finishes dont give the finish that 2 part automotive finishes give, but it was nice to just shake up a couple of cans and shoot! And im pretty happy with the results!

 

[stefanmackey]

I may regret this but i just did this G30 in Rustoleum orange and will do the orange cowl with Spraymax 2K clear after it dries for 5 or so days! The hull was sealed with finishing epoxy resin and then cleared with Spraymax 2K clear! Ive had better finishes, but i dont think that it looks too bad......either way its going to the Internats!!!!

Could you post a picture of how your internals are setup? I'm currently building a G30 with same outboard and trying to figure out. Thank you.

 

[David Krienke]

I think it looks great. Good Job.