ClayGlover
Well-Known Member
- Joined
- Oct 23, 2002
- Messages
- 932
I've got 3 Picco .67 carbs that someone may have a use for.
ONE of them is box-stock and unused. It has the low speed adjustment, stock high-end needle and stock spraybar intact. Barrel throat is 11.50 mm, and neck is 16.0 mm.
The other 2 have been modified for remote needle use. The low speed and high speed needles have been disabled, and therefore will require a remote needle to work properly. The spraybars of these 2 carbs have also been angle cut at the center of the barrel to aproximately 45 degrees toward intake. Please note, I have not run any of these as I got them second hand and sold the boat they came with a while back. I say this not to disclaim myself, but just to be as honest as possible because I really have not had any experience running these carbs at all. The necks (O.D. of the end that plugs into the motor case) of these 2 are also 16.0 mm.
The 2 used ones have typical dings in the outside neck surface from the tightening the set screw on the motor case that secures them to the motor. The dings are superficial and won't affect the carbs performance.
None have O-rings or gaskets for sealing to the case. You will have to get them if needed or gasket seal otherwise.
Maybe someone here might want to play around with them, I don't run this size motor anymore. I've checked them over, and they should work just fine. Of course I will offer 100% money-back satisfaction on the sale should a problem occur or any other reason for non-satisfaction with the deal should arise.
Any and all offers will be entertained, just throw me a number if you're interested. To get something rolling, I think a fair start is $20 for all three.
Thanks for looking guys- Clay Glover
ONE of them is box-stock and unused. It has the low speed adjustment, stock high-end needle and stock spraybar intact. Barrel throat is 11.50 mm, and neck is 16.0 mm.
The other 2 have been modified for remote needle use. The low speed and high speed needles have been disabled, and therefore will require a remote needle to work properly. The spraybars of these 2 carbs have also been angle cut at the center of the barrel to aproximately 45 degrees toward intake. Please note, I have not run any of these as I got them second hand and sold the boat they came with a while back. I say this not to disclaim myself, but just to be as honest as possible because I really have not had any experience running these carbs at all. The necks (O.D. of the end that plugs into the motor case) of these 2 are also 16.0 mm.
The 2 used ones have typical dings in the outside neck surface from the tightening the set screw on the motor case that secures them to the motor. The dings are superficial and won't affect the carbs performance.
None have O-rings or gaskets for sealing to the case. You will have to get them if needed or gasket seal otherwise.
Maybe someone here might want to play around with them, I don't run this size motor anymore. I've checked them over, and they should work just fine. Of course I will offer 100% money-back satisfaction on the sale should a problem occur or any other reason for non-satisfaction with the deal should arise.
Any and all offers will be entertained, just throw me a number if you're interested. To get something rolling, I think a fair start is $20 for all three.
Thanks for looking guys- Clay Glover
Last edited by a moderator:
