10-32 90* water fittings

[FloridaScaleBoater]

Anyone have a source for them
The brass that had the removable barb.
All I'm finding is metric.
Thanks
Rick

 

[P THOMAS]

https://seaducerboats.com/collections/cooling-system/products/water-fitting-90-degree

 

[BobSmith1]

Rick, McMasterr has these, not removable but you can index it. Will try to find the part # if it helps.
( the 90° is to the left under the hose sort of )

 

[FloridaScaleBoater]

Thank you Phil, thems the ones I was needing.
Bob, if you can find the P.N. for the one you show, that would be great.
Looks a little different from what I have gotten from them in the past.
I looked into the curved one's from MECOA,,, $7.40 each. OUCH!!

 

[john v]

Does ose have what you need, good selection of fittings on there site

 

[BobSmith1]

Thank you Phil, thems the ones I was needing.
Bob, if you can find the P.N. for the one you show, that would be great.
Looks a little different from what I have gotten from them in the past.
I looked into the curved one's from MECOA,,, $7.40 each. OUCH!!

hi Rick, so in my MMC history shows 2844K73 however it looks different then the hex style I have, MMC is awesome they might be able to send a picture of the actual item. Now you mention Mecoa, I think there's is fixed, or seperate jam nut, I may have an extra one of those, but think the outlet is very small ( can get you a picture ).

 

[FloridaScaleBoater]

hi Rick, so in my MMC history shows 2844K73 however it looks different then the hex style I have, MMC is awesome they might be able to send a picture of the actual item. Now you mention Mecoa, I think there's is fixed, or seperate jam nut, I may have an extra one of those, but think the outlet is very small ( can get you a picture ).

Just brought up the picture on MMC for your #
I have ordered and used that one.
Where the tubing slides on it is too close to the head & can't get a ty-wrap on them. I do like the as they look kewl but afraid of no ty-wrap.

 

[BobSmith1]

if can you use the Mecoa one message me your # and I'll text you a picture of one I have

 

[brad nichols]

Have you tried Accu_Tech Hardware?

Brad

 

[FloridaScaleBoater]

if can you use the Mecoa one message me your # and I'll text you a picture of one I have

Thanks for the offer Bob,
Lemme see which one you have
678-989-7100 cell#

 

[BrianNeumann]

The Mecoa 10/32 fittings with jam nuts & 90 deg. curved elbows were available in 2 versions when I ordered both styles a few years ago on EBay. 1 is an open hole meant for fuel to carb inlet. The hole is slightly smaller than similar 90 deg. fittings I’ve seen, may create an issue depending on application? 2nd fitting is identical but has a reduced dia. hole to restrict flow to water jacket (going by memory of fitting descriptions on website.) I hope the info helps?
Brian Neumann

 

[Wally Duarte]

Anyone have a source for them
The brass that had the removable barb.
All I'm finding is metric.
Thanks
Rick

How many do you need?

 

[FloridaScaleBoater]

How many do you need?

Thank you Wally,
Jerry @ Ducer has me taken care of.