Search results

John's passing is a loss to the community he was a good person and will be missed.

The Gen 3 cat is one of the best running cat out there, set it up just like Insane's set up sheet and it will run fine. As far as engine and pipe goes you can run just about any combo there is and be happy. Most offshore courses have at least one hard left so you will need a torque engine...

Thanks, Justin

I was looking to get someones unused hardware before I go buy new stuff again. Justin

I am looking for a 21 mini hydro rudder and a flat bottom 21 hydro strut. Thanks Justin

The board that would fry is in the servo, but that would only happen if they were pluged in backward. I would lean toward endpoints on the HS 85. It is possible however rare that the HS 85 was being over drawn on amps and took out the HS 77 or vis versa. Do you remeber if the throttle or rudder...

Did they die on the bench before the boat got run? What size boat is it? The HS 77 does not have a lot of torque especially at 4.8 volts. The HS 85 will not tolerate being over driven for any length of time so I would question end points. Also the Hitec servo connectors do not have alignment...

A brand new carb what ever the model number or where it comes from can pass some trash in the first tank or two of fuel. I would recomend opening it up and cleaning it out and you might as well change the pump and diaphram while you are in there. A stock zenoha carb used to come with black...

Sold

I paid for three gas calenders.

The boat is sold.

PM sent Justin

For sale is an unfinished BlackBird 21 G2 with hardware. The boom tubes have not been mounted and the hull has one coat of west system sealer and filler that is mostlly sanded off. The steering servo is mounted and the the throttle servo mounts are installed. The only holes drilled in the hull...

I would like 850 for the boat hardware and servos shipped. Justin

The props are sold. Justin

Everything but the extra cooling head is still for sale. I am open to offers on the engine, boat, and servos.

There is a member that may take the engine and another member looking at the boat and hardware. I will post what is left after they decide what they want. Thanks Justin

I am open to offers and am willing to break it up. Justin

I am selling my BlackBird 21 G2 + parts and engine to finish the boat. About the boat: It has the glass cloth laid in an one coat of West System epoxy with filler, no new holes have been drilled the sponsons and boom tubes are mocked up but not mounted. The sterring servo is mounted and the...

I will take it give me your address and will get the money in the mail tomorrow at lunch. Justin