Search results

I love my circa-1990's narrow band Airtronics 75mhz pistol radio's. They provided solid operation. I never once experienced a failure. I used 5-cell/6V Rx packs. Also Deans loaded Rx antennas (with short 6-inch screw-on antenna post). I still have a few complete radio's stored away. Just...

thank you very much Roman!

hello, can you provide the dimensions on your rudder blade? (ie. depth, or length X width, etc.,..)

looks like good stuff. I recently purchased some West System G-flex 650, have'nt experimented with it yet.

even after all the effort you put in custom machining that engine and all?

Hi Joe, I'll take 02-quan Picco P67/P80 flywheel collets if you have them (brand new)?

sorry to hear this. My memories of Rod "Geraghty" go back to the 1970's

I've also used this product: https://www.flitz.com/aluminum-pre-clean/ Flitz "Metal Pre-Clean" works very well on aluminum. I spray on engine, scrub with toothbrush, rinse with warm water. Repeat if necessary. Important to not leave product on parts too long (ie. spray-on part, scrub with tooth...

I use a good dish soap (Dawn, etc.,..), hot water and a tooth brush

nice kit! He does nice work.

yes, if those stringers are not too much to remove, I would do so. Then install new plywood rails

I'd opt for a .45 engine as well (current or vintage brand). The Dumas SK Daddle 60, a 35 inch flat-bottom, has: [1] engine (center of glow plug) set @14 inches (just to give you some comparison). So, somewhere between 13.0in and 14.0in should work good. [2] a keel centerline-mounted (1in long)...

I'm curious if the above pipes are equivalent to this attached model? (it is 1 inch as well): https://www.ebay.com/itm/310988833588

I am born & raised Los Angeles Rams! I can still remember the 1980 Superbowl, Rams vs. Steelers (led by Terry Bradshaw), at the Rose Bowl in Pasadena (I live literally 5 minutes from the Rose Bowl). Rams lost! In 1995, Rams move from Los Angeles to St. Louis! What? (L.A. folks pissed off!)...

Hello Derek I have a price listing for the Picco "2011" release version, P45R (blue-head/black case). It lists the crankshaft as part No. 3252 I also attached a drawing documenting dimensions. You can use to check parts you have (note: there are two different cranks in the drawing image- one...

this has to be the most intriguing boat out of all these neat images

I have: 01-quan Carl Brey exhaust throttle, original (1980's) OPS .45 marine ($70.00 shipped- 48 states) 01-quan Carl Brey exhaust manifold, original (1980's) OPS .45 marine ($50.00 shipped- 48 states) I'll post pictures only if interested

Carl Brey made some really nice stuff. I still have a collection of Jet Ring venturi's, exhaust throttles, exhaust header/manifolds

interesting, never seen Seger clips

I hate wrist pin clips