Search results

http://www.minibearings.com.au These guys have always held good stock of Swiss bearings

Is this for os or lawless drive and what engines will work please?

Great info! Looks like you have it sorted Jim. If you ever have 1 or 2 you would part with please let me know. 

Smooth bearings, piston/sleeve/head clean. I ran it once in a mono and stored away properly. Doesn't seem to have had much use. Comes with shaft collet - looks like speed master. $180 USD + Postage from AU

Thanks, will go with the k&s tube

Aeromarine offer a Teflon lined tube, any recommendations to this or standard K&s tube please? Thanks

Thanks for that info, I end up with the throttle and mixture servos like the lower pic and steering servo like upper pic.

Any suggestions to the current best quality and availability. Bought a few flexs in the past that lengths are not quite right and square drive is sloppy. Also experiencing 7.5 stub shafts wear out real quick. I run 3.5 lawless and 7.5 K&B Thanks!

No better way to start a comeback!

Thanks! Will check it

I've got a tidy 67 OPS?

Looking for ideas on the sd3 21 radio box please. Pics would be great. Thanks 

Any input would be great please, hull is JAE 21.

I have one for you, will PM you pics and price.

I dug an old cmb 90 out to run in a mono. Bearings are smooth/feel good, good compression, head clearance checked and good. Started it up on bench, all good. Tried to shut it down closing the carb - no good. Finger over carb, still just runs had to stop it with belt on flywheel. Front gasket...

I have 1 new piston/sleeve that I will work. Send me a PM with your address so I can get you a shipping price.

Great info, thanks!

Ok thanks, so you suggest the start of the flat section or just before

Tried searching for the answer sorry. Where is the best place to put the pressure outlet please? It's a 15cc macs muffled pipe with 1" flat band. Thanks!

Thanks Greg, will PM you