Search results

You can also use a depth micrometer bolt liner down on a couple screw holes bring piston up to top dead center measure then flip the head button measure the step then subtract the two numbers

On the vents I have cut a three side square push the skin inwards and glued wedges on the inside here’s a picture

You said you seen this on 4 pm so what was the fix?

A little over 3 1/4 x 1 3/4

Here’s a picture 30.00 shipped has a used glow plug igniter plug

I have one it’s new but not in package can send picture tomorrow when I get home

Kinda reminds me of a machinist chest very organized worth the effort A Plus !

Life’s battery are safer then lipos plus some of the older radio receivers and servos don’t like the higher voltages that lipos run at 7.4 volts.Make sure you use the balance charger port when charging.Itoo was a old school on batteries my buddys told me what there using and buying from last...

Normally I due but it’s perty good and easy to adjust so for now I’m running it.

I like life battery’s 6.6 volt 2s value hobby’s has 1500 ma packs for 8.00 I have two I been using for over a year now common sense lectron pro charger around 60.00 will charge everything I have from lipo to life batteries and more easy to use.I use it on 110 volts.I liked the charger so ended...

Here’s a few pictures of my boat the right rear side and top of hull was damaged the top rear was completely missing from pipe cutout to around the corner I used g10 1/16 plate two pieces to replaced what was missing had some left over paint from my truck from 2000 I used u pol white laquer...

Do you think moving the weight more forward to like 30 to 33 % would make it ride better with out flipping over that’s where most of my gas monos are

Visited Peter today he’s in a rehab center to build his strength up.Hes doing good not sure when he’s going to get out.He was talking good .Hes up and walking around I was glad to see his progress.

The rudder was back behind the prop and would not turn left shitcanned the extended bracket put the pivot next to prop dog with the shorter bracket boat turns great to the left now.I think what was happening is the prop blast was blasting the rudder blade losing the effect to turn left.I...

I always had my pivot on rudder right around the prop dog.I repaired a damaged razor hull and it was setup with 6 inch bracket for rudder boat does not like to turn left.Never had any problems in the past until I tried the long bracket.I put a shorter bracket but haven’t tried it yet.

Not sure why someone would use white packing foam.Not that hard to go to local hardware store by some pipe insulation or pool noodles.Good luck be careful on removing white stuff.

I wanted to visit him called Mark he said wait another week Pete’s sister said he’s still not doing good.Get well Peter so I can visit you soon.

Way to go Chris nice to see this!

Did you open the case and had a visual on it?

I would try 1 1/2 on low and high you could need a carb rebuild or possible new seals on the crank.Try richen it up first if it don’t idle lean it out but try the richen setting on high I haven’t run that carb in over 10 years.You could try a 257 carb there cheap enough plus bigger then what...